Where to find these dyes

All you need for dying cane is found here.

Dharma Trading Co. has a web site at: Dharma Trading Co.

Their instructions for Wood and Cane: Instructions

Another required ingredient with these dyes: Soda Ash Fixer

To help with color bleeding, used after dying the cane: Dharma Dye Fixative

Comments

Post a Comment

Popular posts from this blog

How I dyed my cane

Using 2.75mm coil of Hamburg cane in the photo below. (these instructions are for an entire coil of the Hamburg cane.) Take a kettle that will hold 1 gal. of warm water. If you use a deep, narrow kettle, a little larger than the uncoiled cane, 1 gal, of warm water will cover the entire coil. There can't be any finish on the material to prevent the dye from seeping in. Natural commercial cane will not dye, so it is necessary to use the Hamburg or Bleached Cane for dying. 1. Determine the amount of lukewarm water needed to completely cover the material and for the material to move around freely. Then for each gallon add one tablespoon of dye (pre-dissolved) and 1/2 cup plain salt. Stir to mix thoroughly. 1 gal. of water in a container that will hold the uncoiled cane, will be enough to submerge the cane for any desired time. In some cases you'll need to add 2 tablespoons of the dye i.e. Chocolate Brown but if your container requires more than one gallon of water to submerge the c...
Read more

Rit Dye

If you're just starting to experiment with dyes, you might want to try the less expensive Rit Dyes - you must how ever use the Dharma Fixative - let it soak for at least 1/2 hour in the solution. This really works for containing the bleeding when using commercial dyes. Rit Dye Website: http://www.ritdye.com They also have a page for creating custom colors: http://www.ritdye.com/Create+Custom+Color.9.lasso
Read more

Using Retayne as a fixative

After letting the cane dry overnight I used Retayne, since I had this on hand, as a fixative to reduce the amount of bleeding when weaving. Instructions for Retayne: 1. Again use your kettle that will hold at least 1 gal of water so you can submerge your cane in it. 2. Dissolve the Retayne in a bowl of 140 degree water, I used very hot tap water, which worked. If the Retayne clumps your water isn't hot enough and requires heating it until the Retayne dissolves. 3. I used 1 tablespoon of Retayne for 1 gal of water. 4. After adding the Retayne to the water, add the cane. Leave the cane in the mixture for 20 minutes. Again I turned the cane after 10 minutes and agitated the cane up and down to make sure all surface areas were covered by the solution. 5. After 20 minutes remove the cane and again rinse in cool water. I have found using the water hose outside for rinsing is very effective in removing excess dye and Retayne. 6. Let the cane dry over night again before weaving. When I dye...
Read more